Control config, how to press OK?

Post tips/tricks or get help with configuring RetroPie
Post Reply
dongilles
Posts: 29
Joined: Sat Dec 24, 2016 8:34 am
Has thanked: 7 times

Control config, how to press OK?

Post by dongilles » Sun Feb 05, 2017 8:40 am

Hey all,

Can someone help me?

When configuring the controls within emulationstation, when I am done configuring I cant press OK to close the configuration window.
How do I do this?

ps. I am using Helders AIO 2.2

oxy93n
Posts: 58
Joined: Sat Dec 03, 2016 2:03 pm
Has thanked: 8 times
Been thanked: 12 times

Re: Control config, how to press OK?

Post by oxy93n » Sun Feb 05, 2017 3:37 pm

Hold down A maybe 4 or 5 seconds did it for me. so press and wait :)

User avatar
144TECH
Posts: 325
Joined: Fri Jan 06, 2017 7:30 am
Location: Amsterdam
Has thanked: 256 times
Been thanked: 71 times

Re: Control config, how to press OK?

Post by 144TECH » Tue Feb 07, 2017 3:33 pm

after calibration complete, press A 1 time. dont hold it.. because then you have to do the setup again. if you press A when you are complete look at the led of the PI blinking.
* Very Rare * GBZ 640x480 v3 Stock Looks 6000MAH
http://www.sudomod.com/forum/viewtopic.php?f=43&t=4863

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest