[GUIDE] Wiring Diagrams: all-in-one board, graceful shutdowns, audio-only board

[yves1984]

Got a question about the On/Off Switch.
I got this one from Ali: http://de.aliexpress.com/item/Details-a ... .68.vQbJGB
My question does it also wor with this one or must i buy some other Switch?

Unbenannt.JPG (25.41 KiB) Viewed 16647 times

The second question is the wiring. the red wiring to the switch is that the On position or the off?
not that i do it wrong an the pi starts when i switch it off and charge when its on

thx

[hueblo]

People are indicating there are different pin outs for the dmg audio jack so this might not work for everyone. Below is how I got my dmg speaker headphone combo to work. Sorry I rendered that with paint haha. Basically short pin 5 and 3 and only connect speaker + to pin 4.

[chaosratt]

People are indicating there are different pin outs for the dmg audio jack so this might not work for everyone. Below is how I got my dmg speaker headphone combo to work. Sorry I rendered that with paint haha. Basically short pin 5 and 3 and only connect speaker + to pin 4.

This worked for me.

[yves1984]

I use the Diagram PJ-343 Audio (v2.5)
got all together now, but got some problem
When i connect my lipo to the adafruit power boost, the blue and red led are shining.
If i push the power button all will be work but the retropie restart all the time. It comes the de logo from retropie and after that it restart again, again and again
have someone the same problem or is it a config problem?

[DeltaShadow]

Capturepwr.PNG (78.19 KiB) Viewed 16542 times

Just wondering why the main ground is run from charging port rather than powerboost is there a reason why this is or does it really matter?

[hueblo]

Capturepwr.PNG

Just wondering why the main ground is run from charging port rather than powerboost is there a reason why this is or does it really matter?

I do believe it does not matter

[darkbrokenheartz]

Does anyone have a schematic or diagram for just the BangGood Power Supply.
Something that shows how the battery goes in, where the battery gets soldered in? And how it goes into the power strip?
Any other caveats that are important does not have to include any safe shutdown stuff.
Thank you

[Fleder]

Does anyone have a schematic or diagram for just the BangGood Power Supply.
Something that shows how the battery goes in, where the battery gets soldered in? And how it goes into the power strip?
Any other caveats that are important does not have to include any safe shutdown stuff.
Thank you

[dboSS]

@a3k4
Can you make the version of gracefull shutdown and Audio only board with teensy?

Thank you.

[a3k4]

@a3k4
Can you make the version of gracefull shutdown and Audio only board with teensy?

Thank you.

Unfortunately I'm pretty busy right now so I don't think I'll have time this week or next. In the meantime: I recommend just looking at both diagrams and taking direction from each where you need it. Is there a lot of interest in this?