Hi,
I am using BW Screen (like Wermy in one of his guides uses) and I put on a bridge on the board of the Screen (for 5V) and then I wired it up to the pi0 (like here http://www.sudomod.com/forum/viewtopic.php?f=22&t=958).
I do not get any reaction from the screen. Do I need to set up the software to get a picture or did I break something? (Pi0 light is on)
Best regards,
Toni
[Help]Monitor - Did I mess up?
- fernandinho1337
- Posts: 37
- Joined: Sat Nov 12, 2016 2:07 pm
- Location: Germany
- Has thanked: 13 times
- Been thanked: 5 times
-
- Posts: 219
- Joined: Wed Nov 16, 2016 3:04 am
- Location: UK
- Has thanked: 3 times
- Been thanked: 73 times
Re: [Help]Monitor - Did I mess up?
gotta try this myself but the way i understand it you need to have OS sd card in to get anything to show. think wermy says the same in his guide
- fernandinho1337
- Posts: 37
- Joined: Sat Nov 12, 2016 2:07 pm
- Location: Germany
- Has thanked: 13 times
- Been thanked: 5 times
Re: [Help]Monitor - Did I mess up?
If i do not have the SD card plugged in nothing at all helps so its different from my problem, but I think i need to install Recalbox and change the config settings (which I cannot do right now but soon will) to disable HDMI. It might be the/ an issue.
Best Regards, TOni
Best Regards, TOni
Who is "Jessie" and why does he like pi(e)?
Who is online
Users browsing this forum: No registered users and 1 guest