So if i load your hex files to a teensey LC, they will work without modification? Sorry, I'm really new to this.HoolyHoo wrote: ↑Sun May 28, 2017 8:03 pmNot hard at all and not much different. Make sure to use same pin out.jermzz wrote: ↑Sun May 28, 2017 6:53 pmHoolyHoo wrote: ↑Sun May 28, 2017 12:45 pm
Well, that's good. Glad you got it sorted out. Battery steps are in 25% increments. So right now you are showing 75%. When its gets to 25%, battery indicator will go yellow and low battery warning video will play once. If you don't recharge and its gets to the last step in battery meter, then shutdown video will play and auto shutdown will begin.
How hard would this be to port over to use on a teensey or audrino Leonardo. Hard even though they're still atmega32u4 based?
looks like on the teensey, I need pins 10 (CS or any pin I read) , 11(MOSI), 12(MISO), and 13(SCK) for the usbasp. ADC0 is just Analog pin 0 right (pin 14)?
and lastly, is there a way I can tell which pins helder used as to which pins I need to use on the teensey to make sure Im using the correct pins for control input?
Thanks for your help HH