Soldering to leads
-
- Posts: 4
- Joined: Sun Jan 08, 2017 1:21 am
- Been thanked: 1 time
Soldering to leads
I have a Raspberry Pi project I'm working on with the Gameboy Pocket version however I'm attempting to uncovered traces on the Gameboy Pocket lower-end where the controls are at. Below is a picture of my control board can anyone highlight areas for me or make arrows pointing to the exact areas that are recommended for uncovering traces? I have already separated the left from the right half by cutting the traces there
- Attachments
-
- IMG_20171013_192348.jpg (3.9 MiB) Viewed 3423 times
Who is online
Users browsing this forum: No registered users and 1 guest