Can you please post the full log from the bottom of the window?
Under "Tools" -> "Board", did you select "Arduino/Genuino Uno"?
Can you please post the full log from the bottom of the window?
If you see my previous post...
floppes wrote: ↑Sun Nov 04, 2018 11:38 pmSorry, I missed the screenshot with the "Tools" menu. Ok, so the Arduino is configured correctly.
Can you please post the full output log? It would be interesting to know which "invalid" libraries were found.
What is the output from the GUI tool when you connect and don't have the display connected?
OK....floppes wrote: ↑Mon Nov 05, 2018 1:35 pmOk, I assume the sketch has been downloaded to the Arduino properly.
Have you tried the GUI with the Arduino connected, but without the display connected? This way we can verify the connection between Arduino and the PC without interference from the display. When you click "Connect", you should get the message "Initialization error: I2C slave not detected". The amber LED should flash with a 200 ms duty cycle.
Code: Select all
Serial.begin(115200);
Code: Select all
Serial.begin(9600);
floppes wrote: ↑Tue Nov 06, 2018 7:08 amOn GitHub two people had similar issues and they solved it by reducing the baud rate to 9600. To do so, change the linein the Arduino code toCode: Select all
Serial.begin(115200);
In the GUI tool, the baud rate is set next to the COM port. I hope this helps...Code: Select all
Serial.begin(9600);
I close program, i launch RTD266xArduino.ino and upload. No errors. After this, here my LED :Reading status info... done
Manufacturer ID: 0x00 (Unknown)
Device ID: 0x00 (Unknown)
JEDEC Manufacturer ID: 0x00 (Unknown)
JEDEC Memory Type: 0x00
JEDEC Capacity: 0x00 (Unknown)
Status: 0x0000
I turn off the Arduino, connect the screen on it, turn on, no blinking LED. I run RTD266xFlash. Press 2 second on reset button. Connect button and obtain :error
Reading status info... error
INFO :error
Reading status info... error
Users browsing this forum: No registered users and 1 guest