Gameboy (DMG) Spacer

[Tiny Desk Engineer]

After nearly completing the gameboy zero with the helpful tutorials I realized something; the innards were too fat for their own good also the battery would never fit, So I poorly designed this spacer.

The SchematicShow

I also realized that I have no cad software experience or a 3d printer available so instead of letting it go to waste I give the blueprints to the Sudomod community for them to use. The measurements should be correct but since I never got a chance to test it who knows.
If anyone does try it out a note: it is meant to be assembled around an existing gameboy zero and glued to the top panel of the gameboy.

[inches]

Thanks for the resource. So this is used to put between the top and bottom half to increase the total inside space?

[Tiny Desk Engineer]

That's correct, the screws should line up and give you much more internal space. In addition the 10mm height of the spacer could theoretically be increased to any size.

[atamagaokashii]

That's cool! I wonder how hard it would be to match the original dmg gray while printing lol

[Tiny Desk Engineer]

Well I've decided to try and attempt to make this by hand out of some heavy cardboard I found.

Edit - so its workable but due to the problems with making it with cardboard the spacer isn't very accurate nor can i keep it closed with screws.
I apologize ahead of time for the awful camera.

SpoilerShow

so you might be wondering what i needed all the extra space for in the first place

for the solar circuit/port of course.

[Killar]

Hi. this seems interesting, i have never seen anyone do this.
At first i thought it looked a bit fat and uncomfortable, but it is enticing to try something new would really want to try and print one .
Did anyone design it for 3d print? STL file?