Exactly what I was looking for, thanks!djbriane wrote: ↑Wed Jun 07, 2017 1:09 pmSomething like this is how I was planning to wire it up (of course the wires would go into Helder's board rather than directly to the RPi):abrugsch wrote: ↑Wed Jun 07, 2017 1:55 amthis diagram should make things clear. instead of wiring the powerboost in, just connect the bat/gnd from the micro-lipo to the 5v line of the Pi, with a simple switch on the Bat line. (ignore the green boards at the top of the pic -it's straight out of the PiGrrl guide)
SpoilerShowmintypi-power-circuit.png
Except instead of running the wires to the Pi you're running the wires to power and ground on the AIO, correct?
Sorry for derailing this thread. I'll keep everything on subject from here on out.