[For Sale, Preorder] DMG pre-cut cases

[kubino]

PSP cut on demand :

PSP_CUT.png (80.8 KiB) Viewed 7239 times

template taken from here : viewtopic.php?t=3944

[vnman]

Hey Kubino -

can you cut the case on demand?

I need the inside of the case trimmed to fit Kedei HDMI screen 8.6 cm * 5.6 cm, can be black if you have one in stock.

PM me

[kubino]

I'm affraid I haven't this kind of screen, so can't cut at the moment.

[vnman]

I am sure more people will be using the 3.5 inch HDMI screen and it is a problem for most people that do not have the right tools.

It is just a case of grinding down both sides of the front case (just a groove that allows the screen to "slide" in. Almost the same as with 640*480 screen that Kite's board is using.

[dryja123]

I bet if you're willing to ship kubino a screen for testing he could probably work something out.

[cobramike]

@ Kubino. Sent me your adress i have 2 of those screens. So you can make somthing happen for him. After that you sent me one back or we can make a deal so you can sent me a nice case. hahaha. Just sent me your adres ill sent you one over.

Greets Mike

[kubino]

@ Kubino. Sent me your adress i have 2 of those screens. So you can make somthing happen for him. After that you sent me one back or we can make a deal so you can sent me a nice case. hahaha. Just sent me your adres ill sent you one over.

Greets Mike

ok, PM sent

thanks Mike. Will see what can I do.

[YaYa]

You are like Nike kubino... Just do it

[kubino]

Now I can offer cut for Erik's bracket :

P_20171126_110306.jpg (1.07 MiB) Viewed 6985 times

Please order the bracket from here viewtopic.php?f=38&t=3364


To have perfect fit you need to manualy trim red area similar way like on following picture :

P_20171126_110533_mod.jpg (1.66 MiB) Viewed 6985 times

Another possibility is to trim bottom part of the button cap.

Huge thanks to Erik for his work in this area

[erik_gee]

Now I can offer cut for Erik's bracket :

P_20171126_110306.jpg

Please order the bracket from here viewtopic.php?f=38&t=3364


To have perfect fit you need to manualy trim red area similar way like on following picture :

P_20171126_110533_mod.jpg

Another possibility is to trim bottom part of the button cap.

Huge thanks to Erik for his work in this area

very nice! The buttons can actually slide vertically in the bracket a fair bit. So if you raise the holes slightly, to where it doesnt hit that lip, the buttons can actually be adjusted upwards as well and not need to have any adjustments to the case though the buttons would sit just slightly higher.