Since I had some trouble receiving the battery, for now I will only ship to germany, to avoid rejected shipments!
Also: I'll make no profit off this, you pay what I payed + shipment.
So here's what you get:
1x 1up kit (2017) (White DMG shell, lots of color options for buttons, see below)
1x fitting battery 3.7V 3000mAh
1x glass screen protector from handheldlegend.com
What you need to buy yourself:
1x Raspberry Pi 3
1x micro SD card
Here's the guide you'll follow, so you know what lies ahead:
https://www.dropbox.com/s/65u2s81p7be33 ... 7.pdf?dl=0
Parts list of the 1up kit:
SpoilerShow
-Gameboy DMG - 01 case
-silicone conducive pads for 6 action buttons
-silicone conducive pad for start and select
-silicone conducive pad for d-pad
-6x action buttons (a,b,x,y and 2 more)
-2x rear action buttons
-1 x d-pad
-original gameboy power switch
- 1up GPIO board
- power switch for PCB
-volume wheel for PCB
-charging circuit PCB
-voltage regulator PCB
-amplifier PCB
-speaker
- 2x 20 male - female GPIO pins.
- 4 male - male GPIO pin
-LCD screen 320x480
-LCD controller board with reverse HDMI adaptor
-2pin JST connector
-3pin JST connector
-analog stick
-3.7v Lipo battery 3000mAh
-power and volume PCB
-rear buttons momentary switches x2
-capacitor x 1
-3.5mm headphone jack male
-3.5mm headphone jack female for PCB
-AA battery connects + and -
- empty gameboy cartridge
- battery testing circuit.
- short section of hot glue.
-2x heat sink for raspberry pi
-silicone conducive pads for 6 action buttons
-silicone conducive pad for start and select
-silicone conducive pad for d-pad
-6x action buttons (a,b,x,y and 2 more)
-2x rear action buttons
-1 x d-pad
-original gameboy power switch
- 1up GPIO board
- power switch for PCB
-volume wheel for PCB
-charging circuit PCB
-voltage regulator PCB
-amplifier PCB
-speaker
- 2x 20 male - female GPIO pins.
- 4 male - male GPIO pin
-LCD screen 320x480
-LCD controller board with reverse HDMI adaptor
-2pin JST connector
-3pin JST connector
-analog stick
-3.7v Lipo battery 3000mAh
-power and volume PCB
-rear buttons momentary switches x2
-capacitor x 1
-3.5mm headphone jack male
-3.5mm headphone jack female for PCB
-AA battery connects + and -
- empty gameboy cartridge
- battery testing circuit.
- short section of hot glue.
-2x heat sink for raspberry pi
SpoilerShow
SpoilerShow
You can choose any 6 buttons and one dpad. I'd like to keep the rest for controller projects of mine...
Note that the buttons from handheldlegend are a bit higher than the original ones. However, I mixed and matched them in my build and it turned out great.
Note that the buttons from handheldlegend are a bit higher than the original ones. However, I mixed and matched them in my build and it turned out great.
SpoilerShow
SpoilerShow