Printed a couple of these and a little bit of feedback:
1. I had to shave a little bit of screw hole cylinder thing on the back part of the case, it was interfering the upper side support of the USB socket spot.
2. I removed the upper left Pi screw post, it was interfering with the screen controller PCB.
Other than that is was great.
[WANTED] 3D Printed Screen, Button, & Component Bracket
- rodocop
- Posts: 1723
- Joined: Mon Aug 22, 2016 3:14 pm
- Location: Saskatchewan
- Has thanked: 606 times
- Been thanked: 608 times
Re: [WANTED] 3D Printed Screen, Button, & Component Bracket
Just printed on myself, definitely will need to remove the screw post to fit my screen board. Also, thanks for the tip about the screw hole and the usb support.jakejm79 wrote: ↑Sat Dec 16, 2017 12:13 pmPrinted a couple of these and a little bit of feedback:
1. I had to shave a little bit of screw hole cylinder thing on the back part of the case, it was interfering the upper side support of the USB socket spot.
2. I removed the upper left Pi screw post, it was interfering with the screen controller PCB.
Other than that is was great.
Also, thanks @Hoolyhoo!
_____________________________________________________
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
My Minty Pi builds:
http://www.sudomod.com/forum/viewtopic.php?f=32&t=3628
My GBZ builds:
http://www.sudomod.com/forum/viewtopic. ... 813#p50813
My modded DMG-01's:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2696
My NESpi:
http://www.sudomod.com/forum/viewtopic.php?f=13&t=2941
My Gaboze Pocaio's
https://sudomod.com/forum/viewtopic.php?f=13&t=6063
Who is online
Users browsing this forum: No registered users and 1 guest