it is really necessary to remove the regulator of the PCB from the screen as shown in the wermy video, because in the screen variants modifications only solder the cable jumper on the pin without removing the regulator.
Thank you
Solved - it is really necessary to remove the regulator of the PCB from the screen ???
- Maury
- Posts: 37
- Joined: Fri Sep 01, 2017 8:36 am
- Location: Chicago Ill.
- Has thanked: 28 times
- Been thanked: 4 times
Solved - it is really necessary to remove the regulator of the PCB from the screen ???
- Attachments
-
- Snap 2017-09-22 at 17.20.45.png (661.89 KiB) Viewed 4070 times
Last edited by Maury on Wed Sep 27, 2017 1:30 pm, edited 1 time in total.
-
- Posts: 392
- Joined: Thu Jun 09, 2016 4:17 am
- Location: uk
- Has thanked: 76 times
- Been thanked: 51 times
Re: it is really necessary to remove the regulator of the PCB from the screen ???
I haven't Modded this screen before but with other variants you could use a jumper wire /or remove the chip.
The models I Modded I was told it would improve the quality a bit by removing it but never noticed a massive difference.
The models I Modded I was told it would improve the quality a bit by removing it but never noticed a massive difference.
Check out my modding and repair channel of retro and modern consoles:
https://www.youtube.com/channel/UCFz7yW ... GtQ/videos
https://www.youtube.com/channel/UCFz7yW ... GtQ/videos
- Maury
- Posts: 37
- Joined: Fri Sep 01, 2017 8:36 am
- Location: Chicago Ill.
- Has thanked: 28 times
- Been thanked: 4 times
Re: it is really necessary to remove the regulator of the PCB from the screen ???
Hi Lpoolm
I have the same opinion I do not see a big different with or without the regulator or the jump cable.
i was under the impression that it might overheat something on the PCB or something similar if the modification wasn't done.
I just got a new screen and this one works better without any mods.
Thanks for your answer.
I have the same opinion I do not see a big different with or without the regulator or the jump cable.
i was under the impression that it might overheat something on the PCB or something similar if the modification wasn't done.
I just got a new screen and this one works better without any mods.
Thanks for your answer.
Who is online
Users browsing this forum: No registered users and 1 guest