Hi guys.
i am going to use the 3.5inch HDMI screen from KeDei on my next build.
there is a backlight switch on the control board.
I was wondering, is it possible to remove that, and add a pot (like the original contrast wheel) to make the backlicht (brightness) variable?
any thoughts?
I am not that good with resistors and calculations on that... so no idea if and how this can be done
brightness wheel on Kedei HDMI?
- BadBert
- Posts: 377
- Joined: Wed Jun 29, 2016 4:14 am
- Location: Hoogerheide, Netherlands
- Has thanked: 100 times
- Been thanked: 61 times
- Contact:
brightness wheel on Kedei HDMI?
My first GBZ build -=HERE=- -> Became a gift to my little brother!
My 2nd GBZ build -=WIP HERE=- -> going with HDMI!
My 2nd GBZ build -=WIP HERE=- -> going with HDMI!
Who is online
Users browsing this forum: No registered users and 1 guest