Need some help getting my workstation ready :)

Talk about anything and everything... Just be nice.
Post Reply
User avatar
NarxElectronics
Posts: 24
Joined: Sat Aug 12, 2017 9:11 pm
Has thanked: 17 times
Been thanked: 23 times

Need some help getting my workstation ready :)

Post by NarxElectronics » Thu Aug 24, 2017 8:48 pm

Hi guys,

Figured I'd be able to get some help and tips from everyone here on getting my workstation together. I've recently jumped into the world of electronics, so my tools are limited. What I have at the moment:

-A giant toolbox with all the general tools
-898D+ Soldering Station (Looking to upgrade to a Hakko FX-888D, pretty dissatisfied with the 898D+, but what was I supposed to expect it's generic)
-Screwdrivers (Big and Small Phillips and Flathead)
-Wire Stripper
-Helping Hands
-Multimeter

I do NOT have a hot glue gun or dremel.

What else would I need? Any other soldering station suggestions?
Last edited by NarxElectronics on Fri Aug 25, 2017 10:55 am, edited 1 time in total.

User avatar
moooarcuuuus
Posts: 232
Joined: Tue Jul 04, 2017 1:28 am
Has thanked: 2 times
Been thanked: 94 times

Re: Need some help getting my workstation ready :)

Post by moooarcuuuus » Fri Aug 25, 2017 12:35 am

Crocodile clip with wires, resistors, capacitors, multimeter and a good power supply. Dont buy too much stuff now. You will get over the time all needed things. The local hardware store is your friend.
Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep, Eat, Sleep... Game Over

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest