sudomod

thanks a lot. I ordered one!

Thanks, just ordered one

Ordered one as well!

Ordered two...

I really hoped that @Camble would release the wiring diagram to build this circuit on my own, but I have to say this is a great deal and with the switch (and of course everything else) not installed, I might be able to place the PCB somewhere else to keep the room.

Camble wrote:The only thing that may trip people up is getting the transistors mixed up, but everything is marked and only goes in one place.

I might challenge your fool-proof setup

Just from the photo of the finished product you posted, the colors indicate that there are 5 different resistors for a total of 6.
So from left to right, we have the small red resistor followed by 5 teal ones. Among the teal resistors, do you confirm that teal resistor number 2 and 3 are identical?

Thanks for all your work.

Eccho wrote:

Camble wrote:The only thing that may trip people up is getting the transistors mixed up, but everything is marked and only goes in one place.

I might challenge your fool-proof setup

Just from the photo of the finished product you posted, the colors indicate that there are 5 different resistors for a total of 6.
So from left to right, we have the small red resistor followed by 5 teal ones. Among the teal resistors, do you confirm that teal resistor number 2 and 3 are identical?

Thanks for all your work.

That's correct. Although, the red one is a diode and must be soldered the correct way round.

Ordered two! Thanks! What are the differences from v1.2?

Unfortunately sending to my country will be expensive and time consuming (Brazil) Would it be possible for me to pay for the PCB and you send the schematic by e-mail?
That way I mount my PCB and you do not need to send a PCB to me.

Thanks

lol

@camble Have these been posted out yet? I wasn't sure if you were waiting until you reach a certain amount of orders or something before you send them out