[For Sale] $7 Game Boy Zero Controller PCB W/ Optional Audio $20 (Worldwide) SOLD OUT
Posted: Thu May 05, 2016 7:04 pm
I have 2 versions of the same PCB, one has built in audio low pass filter and an Audio Amplifier and the other doesn't. The boards are to be used with a Teensy or Arduino board. The board without the audio components will have the locations for them so you can always add them yourself
It's a first come first serve basis and there are paypal fees added to the price which covers the buyer protection they offer so everyone has peace of mind.
Please be sure that your shipping info is up to date on Paypal as that is where the board will be shipped to.
Blue Plain Boards Back (uses PJ-328 Headphone Socket NOT INCLUDED!)
Plain PCB (Don't Wire 5V) Blue Board
For All Orders: $7 Plus $4 Shipping SOLD OUT
Blue v 2.1 Audio Boards
PCB With Audio Buffer and AMP and Headphone Socket Onboard (Must Wire 5V)
For All Orders: $20 Plus $4 Shipping SOLD OUT
Installation & Hole Template:
Break off this Peg:
And cut the retaining wall of original Headphone socket:
Install Board and use a 1/16 inch drill bit for the Pilot Holes:
Then use a larger bit to open the pilot holes up:
Installation guides can be seen here:
http://www.sudomod.com/forum/viewtopic. ... 261#p12261
Fritzing Part of All In One Board:
http://www.mediafire.com/download/3h04e ... g_Part.zip
GitHub Files of older PCB:
https://github.com/Helder1981/Game-Boy- ... roller-PCB
It's a first come first serve basis and there are paypal fees added to the price which covers the buyer protection they offer so everyone has peace of mind.
Please be sure that your shipping info is up to date on Paypal as that is where the board will be shipped to.
Blue Plain Boards Back (uses PJ-328 Headphone Socket NOT INCLUDED!)
Plain PCB (Don't Wire 5V) Blue Board
For All Orders: $7 Plus $4 Shipping SOLD OUT
Blue v 2.1 Audio Boards
PCB With Audio Buffer and AMP and Headphone Socket Onboard (Must Wire 5V)
For All Orders: $20 Plus $4 Shipping SOLD OUT
Installation & Hole Template:
Break off this Peg:
And cut the retaining wall of original Headphone socket:
Install Board and use a 1/16 inch drill bit for the Pilot Holes:
Then use a larger bit to open the pilot holes up:
Installation guides can be seen here:
http://www.sudomod.com/forum/viewtopic. ... 261#p12261
Fritzing Part of All In One Board:
http://www.mediafire.com/download/3h04e ... g_Part.zip
GitHub Files of older PCB:
https://github.com/Helder1981/Game-Boy- ... roller-PCB