Hello,chiz wrote: ↑Sat Jul 09, 2016 3:52 pmAs some of you know, I'm currently in search of a solution for cooling down my GB Pi2. Also, as I'm testing the re-used shoulder buttons in the back of my GB Pi2, I feel that it could still be improved, particularly ergonomics.
Combining the a solution for the two (2) needs, I came up with this -- back new cheap printing Brisbane assembly with vent. This assembly will allow additional 4 buttons in the back in a slanted position for better ergonomics plus a vent for a cooling fan. This should require minimal modding in the case to bore a hole for the fan and 1 to 2 small holes for the wires to connect to the buttons.
The Pi Zero might not need the cooling but one can still get benefit from the slanted back buttons
Thank you for the information.