I have a question concerning the composite solder holes on the PI Zero W.
I have mostly been following Wermy's guide and he uses a PI Zero. The composite video goes in the hole closest to the "TV" marking which is the solder hole towards the SD side of the board and is square in shape....
I have a PI Zero W and the "TV" marking is opposite and by the hole towards the ribbon cable side of the board but is round in shape....
My question is are the holes truly reversed or did they just move the marking? Which pin on the PI Zero W is composite video out and which is the ground?
Thank you for the time.....
PI Zero W composite pinout
-
- Posts: 9
- Joined: Mon Mar 27, 2017 6:52 pm
- Been thanked: 2 times
Re: PI Zero W composite pinout
I think they just changed the markings and not the pins.
Sent from 20,000 leagues under the sea
My Cardboard GBZ build : http://www.sudomod.com/forum/viewtopic.php?f=9&t=2851
EmulationStation optimization for Pi Zero : http://www.sudomod.com/forum/viewtopic.php?f=8&t=2922
My Cardboard GBZ build : http://www.sudomod.com/forum/viewtopic.php?f=9&t=2851
EmulationStation optimization for Pi Zero : http://www.sudomod.com/forum/viewtopic.php?f=8&t=2922
-
- Posts: 50
- Joined: Mon Feb 20, 2017 12:08 am
- Been thanked: 6 times
Who is online
Users browsing this forum: No registered users and 1 guest