Page 1 of 12
DirtyBeagles Build/Progress GBZ (Completed)
Posted: Sun May 08, 2016 3:00 pm
by dirtybeagles
Re: DirtyBeagles Build/Progress
Posted: Sun May 08, 2016 3:01 pm
by dirtybeagles
Re: DirtyBeagles Build/Progress
Posted: Sun May 08, 2016 5:01 pm
by Deadtime
Those look great! You did a very good job, I must say! Keep us posted!
Re: DirtyBeagles Build/Progress
Posted: Sun May 08, 2016 7:51 pm
by crispy_tofu
I like the dogs.
Re: DirtyBeagles Build/Progress
Posted: Wed May 11, 2016 8:04 am
by dirtybeagles
Ready to wire up my display. The only issue I feel I am going to run into is how to covert the power from 12V to 5V. My display was purchased from here:
http://www.amazon.com/BW-3-5-Inch-Monit ... ge_o04_s00
This is what it looks like:
- IMG_20160511_063306.jpg (2.23 MiB) Viewed 10794 times
Has anyone else converted this to 5V yet? Can you link me your progress?
Re: DirtyBeagles Build/Progress
Posted: Wed May 11, 2016 8:57 am
by Spruc3Moose
pretty sure you have the same board as me and I could get it to run on 5V...have you tried it yet?
Re: DirtyBeagles Build/Progress
Posted: Wed May 11, 2016 9:03 am
by dirtybeagles
Spruc3Moose wrote:pretty sure you have the same board as me and I could get it to run on 5V...have you tried it yet?
You "Could" get it to work? Do you have a post somewhere steps?
Re: DirtyBeagles Build/Progress
Posted: Wed May 11, 2016 9:14 am
by Spruc3Moose
I had some pics on the old forum, haven't put any up on the new one yet (I was waiting to make more progress). However, I can confirm that if you have the same board as me (95% confident), it will run off of 5V
without any modifications.
my lcd board with attached wires
Re: DirtyBeagles Build/Progress
Posted: Wed May 11, 2016 9:18 am
by dirtybeagles
Spruc3Moose wrote:I had some pics on the old forum, haven't put any up on the new one yet (I was waiting to make more progress). However, I can confirm that if you have the same board as me (95% confident), it will run off of 5V
without any modifications.
my lcd board with attached wires
I will connect to the RPiZ and test it. if anything I can circle back and do some modifications.
Re: DirtyBeagles Build/Progress
Posted: Thu May 12, 2016 7:41 pm
by dirtybeagles