[SALE] Retro PSU, a 3.5A Output capable Boost Board

[Helder]

I can see about omitting the controls in an update but right now it does use GPIO for controls.

[jungb]

i think this osd and ads1015 not for DPI Screen,only use SPI or AV Screen,because SDA and SCL PIN use for DPI,not enough pin for it
thx

[Helder]

It can be if you use the 565 DPI configuration.

[jungb]

thx helder reply
but if use 565 DPI configuration,how to handle 565 HSYNC and VSYNC two pin,those use for ads1015 sda and scl pin?

[Helder]

thx helder reply
but if use 565 DPI configuration,how to handle 565 HSYNC and VSYNC two pin,those use for ads1015 sda and scl pin?

You're correct, this is geared more towards an SPI or HDMI build since the SDA and SCL are available.

[jungb]

thx helder reply
but if use 565 DPI configuration,how to handle 565 HSYNC and VSYNC two pin,those use for ads1015 sda and scl pin?

You're correct, this is geared more towards an SPI or HDMI build since the SDA and SCL are available.

Thx reply

[NimbleJoshua]

Bought one! Thank you.
It'll be powering a system that pulls up to 2 amps maximum before making battery saving adjustments. I would like to play+charge from time to time (with this charger). Would this put an unreasonable amount of stress on the board?

[KonnorJ]

Bought one! Thank you.
It'll be powering a system that pulls up to 2 amps maximum before making battery saving adjustments. I would like to play+charge from time to time (with this charger). Would this put an unreasonable amount of stress on the board?

That charger will be fine

[Kenshin16]

So I followed the instructions and installed everything, but i get nothing on mine. i just have the SDA and SCL wired up as I'm using a pro micro for my buttons and don't have extra space for a third analog stick. Will this not work?

[Helder]

So I followed the instructions and installed everything, but i get nothing on mine. i just have the SDA and SCL wired up as I'm using a pro micro for my buttons and don't have extra space for a third analog stick. Will this not work?

If you have the pro micro set up as a controller the commands and buttons will not work. Bluup is working on a usb controller version to read buttons. If you mainly need the battery monitor I suggest you comment out the monitor file in the rc.local file then use the instructions here:

https://github.com/sixteenbit/Mintybatterymonitor