WII U RASPBERRY PI 3 FINISHED

[HaBeZse]

Hi!
First of all I am absolutely amazed by your work. I'm literally speechless how cool this project is.
I would like to ask for your help. Can you write down every hardvare's name and if it's possible their prices too like a shopping list? I looked up almost all the links even in the comment thread but just a few of them are still valid and I can't recognize too much on the pictures.
Thank you in advance and good luck for your future projects!

[AntFJ]

Hi!
First of all I am absolutely amazed by your work. I'm literally speechless how cool this project is.
I would like to ask for your help. Can you write down every hardvare's name and if it's possible their prices too like a shopping list? I looked up almost all the links even in the comment thread but just a few of them are still valid and I can't recognize too much on the pictures.
Thank you in advance and good luck for your future projects!

did you miss the front page?

[TomSuperHero]

Hello everybody,
sorry for my bad english but i am from germany.
I have a question you use or have Tenensy 2.0 would make a difference or more effort. To use Teendy 4.0 because it is more powerful
Trank you

[infinitLoop]

Hello everybody,
sorry for my bad english but i am from germany.
I have a question you use or have Tenensy 2.0 would make a difference or more effort. To use Teendy 4.0 because it is more powerful
Trank you

if all you need it for is the controls, then the 4 is way overkill. the 2 is more than enough too, but you'd probably be fine using a Pro Micro clone for a fraction of the cost instead.

[TomSuperHero]

Oh Thank you for the fast answer
Can somebody Update the links in the First Post
Thank dou

[llonden]

If using the RetroPSU, are we supposed to use MintyBatteryMonitor or Helder's OneForAll software?

[infinitLoop]

If using the RetroPSU, are we supposed to use MintyBatteryMonitor or Helder's OneForAll software?

you could use either since the retro psu uses the same chip for monitoring.

[Ema908]

Hi!, excellent project, I am trying to do it, but I have had problems with the usb ports of the raspberry pi 3, since it does not recognize anything (teensy- audio- female usb port) and when turning on the entire device it stays on for a few seconds and then it turns off, when disconnecting the usb ports it turns on normal without problems, Can you help me, I want to know what I am doing wrong, or if the usb ports break down, excuse my bad English, thanks

[AntFJ]

Hey guys... been wanting to share for a long time now. I made a thing... working on the arduino code now

Ill make my own thread when it's done

-Ant

20200330_143950.jpg (2.58 MiB) Viewed 18604 times

[IlMarso91]

Hey guys... been wanting to share for a long time now. I made a thing... working on the arduino code now

Ill make my own thread when it's done

-Ant
20200330_143950.jpg

Working on something similar but can you tell me the name of the joystick connector?