From memory it's one of these pins going to the input 5v I can't be sure which pin cuz I can't find any good pictures from before this.

I finally got the regulator chip off and then tried to solder to the 5v pad on the back and apparently melted to pad off. Did I ruin any hopes of using this board? How hot did you have the soldering iron on. Don't worry I think there's two way round you can hopefully scratch off the area just befor...

Most people don't have a problem and works with no issues .I wanted my one to run off 5v when I got mine it worked but i had a flicker on the screen and i did what I did works fine with no flickering across the screen and its been in my gbz over a month. These boreds are always different some may lo...

When I say chip i do mean the voltage regulator lol

If this one the same I cut out the chip due to flicker then on the back is a 5v pads which I soldered a jumper wire on

Marcus9199 wrote:Finished photos

Hows the analogue stick. Dose it work well. Did you have to reprogram it.
Just asking because I'm putting it on my new biuld but not tested it yet cuz I'm still waiting for my stick to come in the post. Lol

I know what you mean about the cost adding up I did my first one cheap but now I'm doing another one and making with new custum parts and a few added bits similar to you with psp stick. Mines going to be green with a carbon print lol
Good luck with yours you made a good start already.

Looks good how was the space behind it like.
Plus 6 buttons on front not bad

Nottingham in the UK

Hi soon I'll be getting helders AIO board and thinking to making use of the analogue stick part. I'm thinking of using something like this from the psp. But if you already have this in a biuld please share your views e.g type of stick plus any placement of stick issues you came across most I've seen...