I have connected the TX to the GPIO 14 pin of the raspberry and I have configured the /boot/config.txt adding the line at the end. dtoverlay = gpio-poweroff: gpiopin = "14", active_low = "y" That shows VeteranGamer. I give the button to turn on and do the same, turn off the second. Is there somethin...

Thanks helder

I will try later

the truth do not connect it thinking it was not important

Good morning, I have a problem with the project. First of all I'm doing it as Veterangamer all the connections and parts as he recommends. I am also using the wii plate or last one that created helder with all the components welded correctly. The thing is that I have everything connected, then nothi...

Could the USB DAC be removed and connected to the jack connector of the pi itself?

Hi, I'm almost finishing my project. Everything is fine, but I have a question with the audio. Is the connector that carries the DAC that I have removed it valid for the circuit? I want that when I connect the headphones the audio is passed to these and that the speakers stop working and when I remo...

ok, thanks you

How should I buy?

Do I have to choose a version or does the base work well?

veteran, you could pass a diagram of how you have the teensy wired and the code you used. I'm getting the components you use. It seems to me the best way. I have some doubt about what cables to buy to connect everything. And if you advise me some soldering iron that is good for this project and othe...

thank you very much helder

I've been looking at the forum a lot to get ideas on how to do it. the truth and correct me if I'm wrong, I prefer to use a battery system in parallel and using psu retro since it allows monoterizar the battery by the screen and saving a lot of cable in the configuration. Put it in parallel is to ha...