I have tried both sets of software versions 1.3.2and 1.3.3 both screens, neither is turning on. I ran through the initial setup tutorial on "how to setup circuit sword" and everything looked good until this point. Step 11 is as far as i got. I went ahead and tried to start over and now all i have is...

Thanks!

Pixel 3 charger can send out up to 9 volts. Is there a way to test the power board to make sure nothing is wrong with it, I'm sending out my pi/board to be repaired and I would hate to have something get messed up again if there is.

IMG_20190428_210106.jpg I checked everything before firing it up the first time and everything was good. But who knows maybe a couple cycles heated things up. Well you are absolutely correct And funny enough when I looked at it I was like I thought I had more in there. It's actually all over the pl...

1 will not boot from the pi. Processor is too hot to touch within a minute or so of boot attempt. 2 I have a new power board, that has all the fixes already IMG_20190428_185327.jpg 3 it won't even make it that far anymore. I get a white screen, then black and the last thing I get is a message about ...

Got everything set up an was working fine until my first charge. I plugged in a high speed USB 3 charger and noticed the charging light not working. I unplugged and plugged back in a couple of times the high speed cable. After that I switched to an older USB to usb3 and the light appeared to be work...