I put a fresh Image on the stick and now it’s working... thank you.
Back to the temperature, is it normal that without Fan the temperature is always around 60 Celsius ?

Ok ... it’s doing the same, but I think it’s not getting this hot outside of the shell, maybe it was the same before. But I figured out that it’s not freezing befor I try to setup the buttons. Emulation Station setup says „Hold a button to start“ ... in this State it won’t freeze, I can reply this (...

So... it’s getting warm to hot after about 2-3 Minutes. I can still touch the heatsink, but in my opinion it’s very warm for doing nothing than freeze.
I didn’t solder the Fan for now, is it because of that, I think no, or !?

Hi Kite, you remember me … its the board (CS CM3)you had in your hands a couple of days/week ago (Bastian from Germany). You Setup everything (you Changed the Pi3 CM3, updated the Ardunio) . The only Change I made in the Settings, was setting the Resolution to 640 x 480 and solder the Bridge on the ...

I m located in Germany, shipping fees are no problem. As long as it’s very good. Because I already have one and it’s crappy print. Better print to if possible.

Is there someone who can print me this Adapter in good condition or show me a website where it can be done.
Thanks in advance
PM please

Hi Guys, I am a bit new to this, but I finished my project know completely. The problem is, when I switch my Boy on, it boots up normally, but after a while it freezes (seconds, maybe 20-30). It happens normally when I try to setup the button configuration, or maybe in a another state. As faster I a...