Search found 4 matches

by RodneyChops
Fri Nov 01, 2019 8:27 am
Forum: Support (mintyPi)
Topic: MintyPi Practice Solder Boards {Ruin These and NOT Your Real Boards}
Replies: 14
Views: 73544

Re: MintyPi Practice Solder Boards {Ruin These and NOT Your Real Boards}

Don't think I've see those stores in Canada. This meter is the only one they carried at my local hardware store. My brother in law is going to give me a Fluke-117A next time I go see him. He tells me it's more of an electrician meter than anything, but it should beep. I wonder if there is a threshol...
by RodneyChops
Sun Oct 27, 2019 1:36 pm
Forum: Support (mintyPi)
Topic: MintyPi Practice Solder Boards {Ruin These and NOT Your Real Boards}
Replies: 14
Views: 73544

Re: MintyPi Practice Solder Boards {Ruin These and NOT Your Real Boards}

Probably a dumb question, but i'm going to ask it. I've ordered 3 of these, and finished two... Every pin goes great, and shows continuity (near zero resistance on my cheap meter lowest setting 200ohm), except for some reason the ground pins show more resistance... I've gotten the same on two boards...
by RodneyChops
Tue Jul 09, 2019 7:39 am
Forum: Support for Kite's Products
Topic: Newbie Question - Too Easy [Solved]
Replies: 2
Views: 2768

Re: Newbie Question - Too Easy

Very clear answer! I will be certain to check the battery polarity.

Much Appreciated!
Rodney
by RodneyChops
Sun Jul 07, 2019 2:47 pm
Forum: Support for Kite's Products
Topic: Newbie Question - Too Easy [Solved]
Replies: 2
Views: 2768

Newbie Question - Too Easy [Solved]

Hello, Working on a gameboy zero with kite's sword lite. I have a question probably so simple for most of you, i can't seem to find it on the wiki or searching the message board. When plugging in the sword to test it, is there a specific voltage that needs to be supplied? I have a micro usb cable, a...