Yeah, SD card is in. If I connect a usb cable screen turns on with the loader and stuff. I´m using it with a cable to check if everything works. I know my cable setup is a little bit messy, will try to optimise it later. About the burnt, is just the plastic. Am I connecting it wrong? I think it mak...

Yeah, SD card is in. If I connect a usb cable screen turns on with the loader and stuff. I´m using it with a cable to check if everything works. I know my cable setup is a little bit messy, will try to optimise it later. About the burnt, is just the plastic. Am I connecting it wrong? I think it make...

Eehmm...I think I don´t understand you...

The RPI is connected to the "other points". The only part which is connected to the IN in the strip is the cables coming from the power supply.

Am I doing something wrong?

Regards

Hi, I´m just wiring everything just to try if everything goes okay. I just did the power board tutorial. It went fine all the tests: usb, battery and charging. So I just want to test it out with everything connected. I pinpointed the areas with a circled red in the picture. http://i.imgur.com/nJgPIw...

So then, connect the two wires on the amp to the rpi?

Hi guys, Totally beginner building the gbzero. I´m in the part I´m building the audio part. I have the adafruit 2.5w amp connected to the jack, power and two cables. I don´t know where that two cables go. I saw Wermy built an amplifier. Is there any recomendation AIO to get this one? or any webpage ...

Another mod is better and even easier, i'll update my post tomorrow with a picture. Give a second chance to your screen, i doubt that you have fried it. My post is a little bit outdated. Well...I´ve tried again and this time putting something in the SD and voila! I got signal on the screen....!!! B...

Well...I think it happened the same to me as well. I wired the 2dn pin in the circuit but I wired 2 (didn´t realized). So I followed this steps to see if my screen works at 5vs ( http://www.sudomod.com/forum/viewtopic.php?f=22&t=958 ) to check if work but didn´t. I think I fried as well my circuit a...

I´ve just ordered one to the Netherlands.

Waiting for it. Will be great!

Cheers.

Hi,

It's possible to send to the Netherlands?

Cheers!