You'd better hit the punks in the streets instead of trying to escape them hahahaha ;) Nice work. You have a slight misalignment of the screen cover on the bottom right angle (the round actually rounded lol) cheers YaYa, i ordred a gorilla glass gbz screen cover for the project as well as potentiom...

i'm interested in picking a few up, are you planning on making another batch? I have an unused original black gorilla glass screen protector from day. I'd be willing to part with it for what I spent on it. ahh i would have taken you up, i found one on kitchbent so i ordered a couple off of there,

i'm interested in picking a few up, are you planning on making another batch?

i had this same issue while i was working on mine, i ran it to the ground strip where all the power connects to,

i thought that the issue was with my low pass filter when infact it was with the amp.

make sure you ground your lowpass filter also though,

hey guys i finally finished my GBZ i go into the build in this video https://youtu.be/5Lx5kj6I62Y some things i didn't mention i made the screen by shaving down the cover that came with backup monitor i used for the screen i used the kitchbent common ground pcb for the buttons rather than make my ow...

does it have a chmc chip in it? not sure, should be one of the 8 pin chips

i think you can short that and be good

its in /boot/ you need root access to tinker with it.

ssh into your pi and run the command sudo nano /boot/config.txt and you can edit it

hey guys i damaged my screen installing a usb hub into my gbz prototype,

do you know if its possible to order just the lcd screen from anywhere without having to buy the board etc?

yeah you wont see anything if you dont have your sd card with raspbian or retropie etc inserted.
i am getting a wifi dongle to install on my gbz but at the moment its in my media center pi.

i will post my config then if someone else has access to one mind posting it?

did you modify your config.txt for pwm audio?