Helder wrote: ↑

Sat Jul 22, 2017 11:11 am

Send me the screen and lcd board back and I'll replace it.

I have actually got it to lock at this point however the screen is stsying white, any further suggestions or do you think it's dead

2 layers of tape is the max not 4 as I can see the connector lock mechanism bulging out of the socket and it's likely going to break. Where is it bent? The ribbon looks fine to me and as I mentioned in another thread the last 4 pins are not used at all so if those are bent or broken they don't matt...

I noticed my display connector appears to be broken, and bent even. I have tried to trim my cable and went as far as 4 layers of masking tape on the ribbon and it will not lock into place, if I lay my finger behind the ribbon I can get the screen to light up but it just stays white. I have tested to...

Do you email us when our item ships or do you just ship it?

But the cap is not grounded so like I said it's probably a bad value cap and if you have any low value ceramic caps like the small radial ones https://3.imimg.com/data3/OW/GI/MY-2018242/ceramic-capacitor-250x250.jpg you can remove that cap (just apply heat to one side of it for a bit till it comes ...

@Helder I sent you a PM but it doesnt look like its going through. Was you able to watch the video to see what I mean about C7? Please have a little patience I have tons of PMs to go through daily and I'm now sitting down to look at things. I will have a response for you later or early tomorrow. Bu...

@Helder I sent you a PM but it doesnt look like its going through. Was you able to watch the video to see what I mean about C7? Please have a little patience I have tons of PMs to go through daily and I'm now sitting down to look at things. I will have a response for you later or early tomorrow. I ...

@Helder I sent you a PM but it doesnt look like its going through. Was you able to watch the video to see what I mean about C7?

I changed my settings to mono to try and fix, and it didn't help, I've jumped my speakers to the alternate outputs and it's so quiet I can't hear it but if I listen very close I can tell it's clear but again it can barely be heard. I have a video of me touching the capacitor and it working perfect. ...

The last post only helped the choppy sounds actually include some music but still extremely choppy again when I press on c7 it starts playing again but this time I had it playing very well then it got really choppy again.. is there somewhere I can jump c7 to, to test or bridge the circuit in case it...