Hello all. On the website of tinkerBOY, i use the recommended config.txt. Here the config.txt : ####################### #### DPI SETTINGS ##### ####################### dtoverlay=dpi18_666 overscan_left=0 overscan_right=0 overscan_top=0 overscan_bottom=0 enable_dpi_lcd=1 display_default_lcd=1 dpi_gro...

thank you very much for your feedback to you both

@VeteranGamer or @infinitLoop, if i don't use the SPI Adapter and 3.2" screen, you think i can wire your 3.5" version and use the GPIO Assist - Ultra ?

Big thanks for your help.

But i have this glass, i can use it with 3.2" ? :


I have GPIO Assist - Ultra : http://www.pocketadventures.com/product_gpiou10.asp

I can use 3.5" screen with it ?

Hello all.

On this website, i buy this screen adaptater : 18-Pin ILI9341 SPI Adapter

http://www.pocketadventures.com/guide_wiring_spi10.asp

But i can't find the 3.5 screen.

Can you help me ? Any info for this screen ?

Big thanks

I wait any infos too

It's hard

And this new PCB ? I have the old version :

what are all the tracks on the back of the pcb?

VeteranGamer, i wait your news, for a long time I have this project but still delay by GBZ projects.

I can have this PCB ? OSH ?

Big thanks

I don't create new post, i wait responses here. Each KEDEI screen costs me 26 dollars. and every time, I'm unlucky. I take off the screen, I damage the connections (it's my fault). the screen has a problem with the bright panel. one (or more) dead pixels. I'm tired. and it costs me a lot of money (a...

I send the firmware. Hard to wait an update

I pause the project because after that it will be difficult to access the HDMI port.

i don't edit my first post if it can help VeteranGamer. After edit 115200 by 9600 in RTD266xArduino.ino and specify 9600 in Baud Rate, i can connect and read status : Connection successful! Reading status info... done Manufacturer ID: 0xC8 (Bright Moon Semiconductor Co., Ltd) Device ID: 0x12 (T25S40...