Yes like I said it's a SAIO Rev. 0.6c with a Pi Zero. I have repeated the calibration process many times. Last time with another Joystick (PSP1000) but with no luck. Which code do I have to upload to the arduino? The last one as described here: https://github.com/kiteretro/Super-AIO/wiki/Updating-Ar...
I want to activate the Joy2 and when I measure with a multimeter 3.3 volts are applied. I have tested 2 PS Vita 2000 Joysticks but none of them work. I have tried to calibrate them. nothing happens! Do I need to activate them like the CSO? https://github.com/kiteretro/Circuit-Sword/wiki/Configuring-...
If you put SD into PC and look in file "config-cs.txt", does this line read: # Cloner settings CLONER=ON ? If not, change it to that.. It's "ON". If you have SSH or press F4 to get to console, what happens when you run: sudo systemctl start dpi-cloner.service Nothing happens. But PS says dpi-cloner...
Yes, it shows a black screen on two different screens (TV/Monitor). It even shows the correct resolution (640x480) on the TV. Only the screen remains black. I can leaf it connected for longer. It should have been over 30 minutes.
I got a Kite CSO with rev. 1.2A. After I connect to a TV via HDMI I get a black screen. What could that be? Is there a switch I need to activate or something else?