Hi Kite! Sorry I didn't answered you before: you were right, the Joystick was pushing the whole thing and causing the issue. Now I have almost completed my build, but I have encounter another problem regarding the joystick that I hope you can help me with: - The Joystick is only working on the X axi...

Hi Kite

See attached some pics and a video with the issue.

Thanks!

Hi I just had a weird issue when I was about to (finally!) close the case. I was playing around retropie as usual, but suddenly the screen faded to white. I searched on the forums, and then checked the CM3 adaptor pins. After really clean then carefully, the issue seemed to be gone, but after a few ...

You might try a boiling water trick. But it is risky. Might not be worth the risk. But I don't think it will help with that litte white spot in the middle where the screw tip went. http://www.tfw2005.com/boards/threads/boiling-plastic-in-water-to-remove-stress-marks.485448/ I finally tried using a ...

Hi Hoolyhoo

Do you have the A101 buttons in grey? from the picture is hard to see clearly.

Hi Yesterday I was finalizing the front of my Kite's CM3 build when I introduced a screw a little bit longer than it needed (tremendous mistake from my side), in one the of the spaces the board has for screwing to the case supports. The consequence was a small decolorization below the "A" button, yo...

Ordered one!, Thanks a lot for this Erik!

Hi HoolyHoo, I sent you a PM!

Really amazing! I was wondering, is it possible to use this PCB with DMG buttons instead of the ones provided (A101 maybe?), I would prefer to use slightly larger ones and checking your pictures it seems that it should be enough space for them at the back. DMG buttons may seem to fit but the insert...

Probably you have thought about this already but, wouldn't be possible to use the DMG wells that you did for your other PCB? (https://www.sudomod.com/forum/viewtopic.php?f=38&t=5248) Both PCB seems to share the same style, except for the obvious row vs line layout.