Search found 34 matches
- Mon May 07, 2018 8:35 am
- Forum: Show-off Corner
- Topic: My DIY pink machine
- Replies: 0
- Views: 2025
My DIY pink machine
Here is my super grungy DIY build. https://thumb.ibb.co/m8sjg7/20180506_154139.jpg Started off wiring up a 2.2inch spi screen (thanks for the guide Moosepr) https://thumb.ibb.co/iTOnZS/IMG_20180503_WA0002.jpg I have changed the wires to silicone wires since. Added a banggood boost and some LEDs for ...
- Sun Jul 30, 2017 2:28 pm
- Forum: Support (Game Boy Zero)
- Topic: weird behaviour of buttons
- Replies: 8
- Views: 7142
Re: weird behaviour of buttons
Looks like this should be in the gbz area of the forum, rather than the minti pi one.
I'm sure one of the mod guys will move it for ya
Are all of the buttons and membranes held nice and tightly together with no wiggle room?
I'm sure one of the mod guys will move it for ya
Are all of the buttons and membranes held nice and tightly together with no wiggle room?
- Thu Jul 27, 2017 12:46 pm
- Forum: General Chat (mintyPi)
- Topic: mintyPi Build Guide
- Replies: 8
- Views: 27474
- Tue Jul 25, 2017 9:41 am
- Forum: Show-off Corner (mintyPi)
- Topic: Birthday Pi
- Replies: 6
- Views: 6694
Re: Birthday Pi
Haha, I don't know what that is so no hope someone gets your reference though
- Tue Jul 25, 2017 7:04 am
- Forum: Show-off Corner (mintyPi)
- Topic: obsidianspider's mintyPi
- Replies: 24
- Views: 18636
Re: obsidianspider's mintyPi
I used a banggood boost and mine won't close properly because of that. It's close enough to keep the insides safe though
- Tue Jul 25, 2017 7:02 am
- Forum: Show-off Corner (mintyPi)
- Topic: Birthday Pi
- Replies: 6
- Views: 6694
- Tue Jul 25, 2017 5:04 am
- Forum: Support (mintyPi)
- Topic: White screen
- Replies: 78
- Views: 56127
Re: White screen
When you unplug the power is there still continuity between 5v and gnd?
- Sun Jul 23, 2017 2:38 pm
- Forum: Show-off Corner (mintyPi)
- Topic: Birthday Pi
- Replies: 6
- Views: 6694
Birthday Pi
So, this is basically standard. It was my girlfriend's birthday on the 21st and I tried to get it finished by then but ill finish it off tomorrow. Used the board and screen from helder and the 3d printed bits from wermy, the usb sound card, a powerboost and an adafruit battery... super standard. Onl...
- Sun Jul 23, 2017 4:55 am
- Forum: General Chat (mintyPi)
- Topic: piGRRL custom pcb in a minty pi
- Replies: 2
- Views: 3226
Re: piGRRL custom pcb in a minty pi
I tried this and it was a smidge too thick with the other bits in. Someone else might have succeeded though
- Fri Jul 21, 2017 3:40 am
- Forum: Support (mintyPi)
- Topic: Heat
- Replies: 4
- Views: 4536
Re: Heat
Thanks helder. I'll remove the powerboost completely and run off power to pi for a test. Cheers