Can you link to the guide you found to cut the board down smaller? I had ordered two of the backup screens a year ago and got one with a big board like that, not sure it's the same one but at least that might point me in the direction to make use of it. :) Not a guide per se.. I can't figure it out...

Hex wrote: ↑

Wed Aug 09, 2017 12:20 am

Can you check the part number of IC7. It is certainly your voltage converter.

Yes, that is the Voltage regulator. LX1509 do I need a jumper on the output pin?

Hi I've got another screen since i ruined the last one. Now this one is completely different. Its all in one and too big. with the code 1633 on it. I have found a guide on how to cut it down to fit into the GB case, but how do i convert it to work on 5v. I have ran the screen off a 9v battery and wo...

Thanks for that. I don't have a multimeter. In hindsight I should have soldered a jumper first. I have removed the chip now. And soldered 5v to where the output pin of the IC should be. Now I'm getting a solid black Color on the screen. But I'm not getting any signal showing on the screen. I have th...

After lots and lots of searching. I have found another thread with a possible solution. http://www.sudomod.com/forum/viewtopic.php?f=8&t=3053 They have v5 of this board and I have a newer v6. The o my major difference is that JW IC is rotated 180 degrees. I've tried googling information or schematic...

Hey Guys, First post here. I just started with getting my screen ready. And I seem to have a different board to the ones listed on the wiki. I have tried to power the screen with 5v but I don't get a backlight, just some vertical lines throughout the screen, kinda hard to take a photo of it. My gues...