Hey @prerunnerseth I was curious what those other solder pads are for on the "left" side of the pcb? Are they for adding custom components or future addons? Would be cool if a wifi module or antenna would fit inside

Hey Dom sorry to hear about the break in. It's quite a mental shock and it takes some time to get back to normal without using 6 deadbolt locks on every door and window. I ordered your gameboy zero screen cover and a cartridge label. Being in Canada everything comes at a snales pace so I'm in no rus...

Hey Helder I haven't yet started my project since I don't have all I need just yet (living in Canada shipping is a pain) but I would like to thank you for all you have done and continue to do for us both active in the community and those whom remain anonymous. Your a power house for dealing with iss...

Could this screen work? I know it's a touch screen but just curious. http://www.digikey.ca/product-detail/en/seeed-technology-co-ltd/308010014/1597-1060-ND/5482538 Hate to burst your bubble but mostlikely not. It's going to block off some nessisary pins you need and the header looks bulky and will ...

Helder did thank me for my post so that must be what he plans to do. It's what he's done from the start so I'm assuming me won't change course from there. And I think the name claiming was for a pm to him for those who got defective audio boards could stake to a replacement but that was it

Hey guys the pre order doesn't work that way. Helder will set up a pre order link in the first page of this post. That way he has an electronic record of whom and how many so he can arrange shipment and his order to the manufacturer. On a separate note has anyone completed their gb0 "helders way" di...

Hey Helder I just got my 10mm tactile switches and was wondering if there's any perticular way they are soldered onto the pcb board? Noob question I know

What is switch for? And where does the speaker negative go? If you didn't isolate that ground pad from common ground then your going to have the same issue as before The setup is basically the same as the first picture on the first post. When I get the boards in I'll make a new wiring diagram. That...

What is switch for? And where does the speaker negative go? If you didn't isolate that ground pad from common ground then your going to have the same issue as before

Hey @Helder would it be possible to see a circuit diagram of the old audio board and the new one? I wanna know if you just applied your hot fix from the old board to the new one or its be redesigned completely. I would like to get one of the new ones on the next run or the one after but I would lik...