What pins on the original power switch should we use?

i would like to know how to do this as well. Not a lot of info on it

I have everything wired up to the powerboost 500c. I have the 1000c on order. Anyway, I have the micro usb wired and the original power switch wired in the correct places. The power switch works as it should and cuts power when i turn it to the off position. When I plug in the power the blue light a...

I just needed to search the forum a little harder. I found fleders guide which helped me immensely.

I am using a backup tft screen for my project and I just had a couple questions that I'm trying to clear up before continuing. I have it running on 5vlt just fine and I get a picture when connected to a video source using the yellow composite cable. I'm ready to solder the wires to the raspberry pi ...

Sweet thanks. That makes more sense

Thank you for the reply. So if I am understanding correctly, I'm going to wire the two longest wires to the same USB and Gnd that the micro usb charging port is soldered to?

I'm following wermys guide on how to wire everything up and I don't know where to wire the prototype board to the power boost so that I can get power to the screen and raspberry pi and anything else? I've included a image of the board I'm talking about. Any help would be greatly appreciated. Thanks ...

I appreciate all feedback on these screen surrounds, and if something is wrong I will do my best to fix it. I have tested the screen size on about 10 gameboy cases so far, and a couple were tight, only as much to fit without glue. There wasn't any bending or bowing. Having said that, I have a suspi...

Are these supposed to sit flush with the top of the gameboy case (like the original gameboy screen covre) or does it sit a little bit above? I left a small lip on the gameboy case and went to put in the screen surround and it sits up so I have an edge. Do I need to sand the edges of the screen surr...