Audio is now sorted for me, I used 4.7 Ohm resistors on the R17 & R18 pads the R15 & R16 pads are still 10 Ohm with 100 Ohm soldered to the right of them then going to the speakers negative side. I set the volume in alsamixer to the max I could without audio cutout then in each emulator while a game...

That's an older version of the board because I used 200 ohm resistors on that version, best thing to do is use lower value resistors in place of those on there right now so you might have to remove them completely. Some might wonder why the value is high on this board version and that was to find a...

I too ordered 75Ω 0806 in the hope to boost audio a bit louder. I'll keep you informed of the results (but as it's coming from overseas, it may take some time). I however notice some high pitched noise since the mod, but it's really faint, so I don't mind. I haven't noticed any high pitch noise but...

Adventures of Boubobo in bodgeland http://stuff.knackes.com/dld/201703/IMG_3528_E80D80CE.jpg I did this and it helped a lot, R15, R16, R17 and R18 are now 10ohm and I have 2 100ohm in the same way as above and it has boosted the speaker volume and I get less audio cut out on the games I had issues ...

hi, being a bit lazy and do not want to mod an original controller board so after the most basic board, do not need an aio just the one with the added x/y buttons. in the uk and looking to try and get one for the weekend if possible? thanks You can order them from OSH Park I have ordered from them ...

Put my order in

If you could use the gpio out of the box, everyone would solder the wires there my friend. And he has to power it up first.. and you can't damage anything, these points are just as big as the solder pads, no risk nothing unless you are a amateur solder mcgyver. And by the way a pi zero cost like 10...

144TECH wrote:all this discussion about nothing.. omg.. you can just solder them ontop, right next to the usb port. i'm gonna quit this topic, lol

Why solder them to an area that may harm or destroy other components when the GPIO will do the job just as well and is intended to be soldered to?

Dextech wrote:Preorder links are in first post. Go for it

Same here as above next week when I get paid, in for 2.

Just found this:

http://r.ebay.com/MhMGTF

Just wondered if it would be any good, could the GBZ components be split between the 2 power sources on this charge board?