YaYa wrote: ↑

Thu Oct 26, 2017 12:56 pm

Damazeltov wrote: ↑

Thu Oct 26, 2017 12:54 pm

Thank you for your Ram/Cpu saving guide! I managed it to let my pi3 booting up retropie in under 10 seconds

Impressive

https://www.youtube.com/watch?v=k8-F8p6qWj8

Thank you for your Ram/Cpu saving guide! I managed it to let my pi3 booting up retropie in under 10 seconds

They are both 22ohm, so when put in parrallel (one on top of the other) will be 11ohm :) Yeh the new boards just have a solder jumper so it's a lot easier :) What resistor is on the new board? Also 11 Ohm? Is it possible to install a 10ohm instead of 11 and get the display even brighter? New boards...

old one is still alive, found it on my shelf :lol: so the old one is 22 ohm. how much was the supplied one together with the display? They are both 22ohm, so when put in parrallel (one on top of the other) will be 11ohm :) Yeh the new boards just have a solder jumper so it's a lot easier :) What re...

old one is still alive, found it on my shelf :lol: so the old one is 22 ohm. how much was the supplied one together with the display? They are both 22ohm, so when put in parrallel (one on top of the other) will be 11ohm :) Yeh the new boards just have a solder jumper so it's a lot easier :) Just ri...

it was also crazy to desolder the small resistor

old one is still alive, found it on my shelf

so the old one is 22 ohm. how much was the supplied one together with the display?

Did you solder the "BLBOOST" jumper on the SAIO? or if you were using the older versions of the board did you solder on the included resistor? I have the 0.6c board and soldered the included resistor on R52. I measured the resistor after soldering with 22 ohm. Can you re-do the solder, especially o...

Very nice and clean! Great build! Where did you get those back trigger buttons? There are plenty of different set´s on ebay ;) Do you have the link? I wasn't sure what exact measurements they were to look them up. Thanks in advance! http://www.ebay.de/itm/10-x-Mikrotaster-Hubtaster-6-x-6-x-5-Drucks...

Very nice good work on the screen! This is the first build i've seen using the screen (apart from Kubino with his test prints) so good work, it looks great! :D Thank you for your great support. It was not really difficult at all to install the screen. For the upper screws I printed wermy's upper sc...