Please check the following:
* battery voltage with a multimeter (should bei between 3.0 and 4.2V)
* output voltage of powerboost (b+ and b-), connected to usb charger
* output voltage of powerboost big usb (underside pads) - should be between 5.0 and 5.2V)

Another method if youre GBZ uses GPIO for controls, you can set up a new wifi network using the password "aabbxxyy". 😊👍 very creative, I like that :lol: I will try to move the raspberry a littlle bit to the right, so that the sd card slot is accessable with tweezers. The buyer will get a free tweez...

Hi, I have a GameBoy zero with a Raspberry Pi Zero W inside it. I would like to sell it, because I have another one build with Kites Circuit Sword. The problem is: The raspberry pi zero w is sitting in the middle of the case and there is no access to the sdcard or usb from the outside, so the buyer ...

There is also a diagram on the new RTFM (should be finished the next month and translated until August) section, which illustrates the "power-saving mode". I have attached a picture https://www.zeroboy.eu/wp-content/uploads/2018/06/kedei_energiesparen_mod.jpg description from one of our members, yo...

thanks.... but, i'm not a fan of this Zeroboy, so i'll be giving that a miss..... hes a bit deluded from my experience with him.... besides i don't think he actual shows how to modify the screen itself (not the board) so that it will fit... (there are two different sizes of the screen, one marginal...

I am using the Kedei HDMI display and have been experimenting with its power supply. It has the DS1117 as well, but three times: one for 1.8V and two for 3.3V. The 1.8V is for the central display controller RTD2660. One of the 3.3V is for the LCD and it's backlight. The other one seems to supply th...

... Thank you for your help, I actually cracked the LCD screen on that one - and now I've actually severed that entire connector described in that thread - I'll continue my discussion there. You're welcome! The difficult part is now to find a exact matching replacement screen with the correct numbe...

well...thats unnerving...thats the pins i used. Crap lol... Ugh that means either the pins w/o the jack are different than just tapping off the top of the jack, i damaged it removing it (doesnt look like i damaged it), or my amp is messed up. I hear popping noises in the speaker, which is usually a...

Hey Salami, out of curiosity do you know the pinouts for the headphone jack? I think i screwed up by pulling the jack off the board ahead of time lol. Having difficulty finding out what pinhole is what. Hi, i dont have the gameboy around currently. But you can use this image: http://image.ibb.co/eV...

Hi, my order arrived a few days ago in transparent filament. Thanks HoolyHoo!