hello man, I have exactly the same issue. When the battery voltage drops to 3.2v. the screen starts to blink and the usb hub doesn't work and I plug in the charger in the microusb port and it doesn't charge the battery because the gbz shuts off. Did you find any solution? Is it just made of this way...

How many time to charge full the battery?

Hello guys. Lately I realized when the battery is low (when the LED is red) the screen blinks until it switch off. I though it was a problem because even when I connect the charger to charge the battery the screen goes down anyway.
Is this normal or there's a defect on the powerboost/battery?

I have an issue with the buttons suddenly, before they worked good. When I press the A for example, it gives me an A but sometimes give me another like X or that, and the left direction pad doesn't work ( the A letter would be, left move). Why happend this? I try with other rubber pads and plastic p...

Fixed: Instead of solder pp35 and 40, I had to solder the ID pin of the microusb socket directlt to ground, now it works perfectly

I found a solution. PP22 and 23 wired to the hub didn't work, even with PP35 and 40 wired, so I insert a microusb-otg and wire only the data wires to the hub. Now it detects teensy and keyboard, but I problem arrived: I can't have one microusb cable in the case, its too big, and I think if I wire to...

Well thanks for the help but didn't work for me xd my hub only "catches" one signal. I have it well wired but the might be some reason. I have PP22 and PP23 in the input hub and supplying by the powerboost, then I got the teensy and keyboard. It detects the teensy but if I disconnect it then detects...

I didn't know any of this!!! I will try tomorrow thanks

thank you very much for that introduction, it helps a lot

@rodocop Which is the first step to do GPIO buttons method? I read PRS guide but I have a doubt, Do I have to have the RaspPi connected to a television? The pcb button has to be wired first to the GPIO? I have all glued but my teensy don't work... so would be a little messy to clean all...