kite wrote: ↑

Sat Oct 12, 2019 7:25 am

When the joysticks are plugged in, what do the readings of the analog values show? Are they wildly changing?

Only the 1st joy changes values by itself between 830 to 990 and if you keeps pressing enter to refresh eventually it jumps to ridiculous -30000

kite wrote: ↑

Fri Oct 11, 2019 8:57 am

Do you have any joys connected (or plan to)? If not then disable them

The plan was to use dual joystick, GB shell prepared. Is it a board/component fault ?

Arduino flashed OK but issue still persist. When running python Circuit-Sword/cs-configure.py if JOY 1 is enabled refreshing the page shows movement on X with nothing connected. If disabled an only joy2 is on everything is ok. Any ideas?

All of sudden buttons presses by itself even after fresh sd image and no rubbers attached. Config of buttons in emulation station impossible. Any ideas what can be the reason for this?

Update: When configuring D-pad -> D-PAD UP enters by itself AXIS 0+ but no joystick is physically connected.

Hi Banjo. I was wondering whether the code in the first post of this thread is up to date and functional as-is; when I try to verify in the Arduino IDE, namely, it says "Joystick" does not exist (makes sense, since it's never imported or anything). Furthermore, the code and code comments don't matc...

Hi, I'm almost finishing my project. Everything is fine, but I have a question with the audio. Is the connector that carries the DAC that I have removed it valid for the circuit? I want that when I connect the headphones the audio is passed to these and that the speakers stop working and when I rem...

tyon2006 wrote: ↑

Thu Jun 13, 2019 7:42 pm

Thanks for the previous responses Can you tell me how you got the home/power pcb printed? Did you use a specific service? Would you be willing to share your design file, if available?

The pcb is so simple I have done it at home with the yellow paper transfer method for laser printer.

How did you go from the joysticks to the teensy? Did you solder in a new connection or did you make use of the existing white wire connector for the original hardware? In this project I made a custom pcb to hold the teensy 2++ and fpc connectors for the joysticks and buttons. This is what I'm refer...

Hi Banjokazooie ! I have just finished my build and I'm using your code. I experience a strange behavior with the analog sticks. My left stick works flawless, up and down on the right stick too but left and right are recognised like left and right of the other stick... My first thought was a bad so...

tyon2006 wrote: ↑

Thu Jun 06, 2019 12:22 pm

How did you go from the joysticks to the teensy? Did you solder in a new connection or did you make use of the existing white wire connector for the original hardware?

In this project I made a custom pcb to hold the teensy 2++ and fpc connectors for the joysticks and buttons.