Xbox series 2 elite rework.

Got an idea for a project? Found a cool project you want to share? Post it here!
Post Reply
Irishmcirish
Posts: 1
Joined: Fri Jul 09, 2021 7:25 pm

Xbox series 2 elite rework.

Post by Irishmcirish » Fri Jul 09, 2021 7:44 pm

I hope this is the right place to post. I'm attempting to rework my broken Xbox controller after my SO spilled her bowl of Ramen on it. I'm hoping someone might have some details on the spring connectors on the analog stick pcb. The printed board locations are j15 through j22. I have some mediocre calipers and measured them at 1.4mm uncompressed height from the board 1mm width and 2.4mm in length. Thanks to anyone who looks at this.
Attachments
16258813463107683966014481551469.jpg
Connecting board.
16258813463107683966014481551469.jpg (1.04 MiB) Viewed 4820 times
16258813006031775089344457174238.jpg
16258813006031775089344457174238.jpg (1.91 MiB) Viewed 4820 times
16258812206465403680008162090952.jpg
Spring connectors.
16258812206465403680008162090952.jpg (987.42 KiB) Viewed 4820 times

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest