Can I attach the SD card adapter pinouts to any pins on the cartridge by Kitsch-bent? I ordered the one without the already installed sd card reader.. then just follow those down to the cartridge reader?
Or are there certain pads I must tap into.
Using Kitsch-Bent PCB for cartridge
-
Thatbraziliann
- Posts: 97
- Joined: Wed May 04, 2016 10:04 pm
- Has thanked: 4 times
- Been thanked: 2 times
-
wermy
- Site Admin
- Posts: 1346
- Joined: Tue May 03, 2016 8:51 pm
- Has thanked: 620 times
- Been thanked: 1322 times
- Contact:
Re: Using Kitsch-Bent PCB for cartridge
You mean this one? http://store.kitsch-bent.com/product/kk_gb_brkoutThatbraziliann wrote:Can I attach the SD card adapter pinouts to any pins on the cartridge by Kitsch-bent? I ordered the one without the already installed sd card reader.. then just follow those down to the cartridge reader?
Or are there certain pads I must tap into.
If so then you can pick whichever ones you want and just match them up, yes.
If you mean this one: http://store.kitsch-bent.com/product/kk_gb_zero_b
Then yes you have to trace them down.
-
Thatbraziliann
- Posts: 97
- Joined: Wed May 04, 2016 10:04 pm
- Has thanked: 4 times
- Been thanked: 2 times
Re: Using Kitsch-Bent PCB for cartridge
@wermy thanks for the quick response man!! So pumped I got the top one because tapping into traces doesnt seem to be my forte haha. Ill post pics if I run into any trouble along the way.
Who is online
Users browsing this forum: No registered users and 1 guest