Straight up front, I have to say all the code is based on Sota’s 14 button + 2 Analog controller tutorial. I doubt I could have done any of this without that amazing tutorial.
https://www.sudomod.com/forum/viewtopic.php?f=22&t=1766
With that said, if you have a Arduino Pro Micro and a voltmeter, you can easily do what I did. But I’ll post the pads and vias I used to wire an old WonderSwan Monochrome to an Arduino.
- EFD45853-25C5-45E4-8AEE-90FBDD5A319C.jpeg (2.42 MiB) Viewed 4672 times
So once you’ve found the traces, I used 0.1mm magnet wire to connect them to the Pro Micro. A note on using magnet wire: the ceramic coating will melt off when exposed to melted solder. So don’t try to scrape it off with sandpaper of a blade, you’ll just break the wire. All you need to do is use the wire like your using bare copper wire with the added benefit of not causing shorts if the wires touch.
First I made sure all the ground points were linked up. Most of the buttons share a common ground, but the right side of the board and the Sound/Start pads need to me connected.
Then I added wires to each test pad or via that were isolated. After that, I had a bit of a rats nest so I made sure that each wire went to a pin hole on the Pro Micro and the combined ground wire got a ground pin hole.
Then I just kind of shoved it all inside the case, a red it back together and glued the Pro Micro in the game slot. I added a bit of Kapton tape to keep it stil while the glue cured and to protect the exposed wires and electronics.
I may, down the line add an emptied out game to cover up the Pro Micro, but my Dremel is dead
Any questions, feel free to ask!
