sudomod

Hello

Im working on a project which runs on a arduino nano. im running audio out of one of the pins. So its got some noise which I imagine is similar to that out of the GPIO pins on the Rpi. Would helders PWM audio filter help with this? Looking at the board there are 2 PWM pins. I presume this is just audio in?
Can anyone confirm if this is the case?

Each one is a separate channel but if you only have one just use one of the 2.

Helder wrote: ↑

Tue Jan 22, 2019 3:28 am

Each one is a separate channel but if you only have one just use one of the 2.

Thanks Helder
Yeah I only need 1 channel. Im ordering the bare board from OSH Park. Im guessing I only need to populate half the board then?

Thanks again for the reply mate

yes just half is needed.