sudomod

Not sure if I should even call this idea a mintpi anymore. So essentially it would be a MintyPi but with a bigger 3Dprinted enclosure so I could fit a bigger screen, a camera, a pi 3 a+, a joystick and a dpad, and more. (Now that I think about it this is just a 3DS XL without the bottom screen but screw it it’s a MintyPi+)

Edit because of the naming confusion let’s call this a PrintyPi

StaticNebula26 wrote: ↑

Sun Mar 10, 2019 10:05 pm

Not sure if I should even call this idea a mintpi anymore. So essentially it would be a MintyPi but with a bigger 3Dprinted enclosure so I could fit a bigger screen, a camera, a pi 3 a+, a joystick and a dpad, and more. (Now that I think about it this is just a 3DS XL without the bottom screen but screw it it’s a MintyPi+)

Really.....

That sounds like an original idea.....

viewtopic.php?f=32&t=4446



.

can you put it in a bigger tin

VeteranGamer wrote: ↑

Mon Mar 11, 2019 6:32 am

StaticNebula26 wrote: ↑

Sun Mar 10, 2019 10:05 pm

Not sure if I should even call this idea a mintpi anymore. So essentially it would be a MintyPi but with a bigger 3Dprinted enclosure so I could fit a bigger screen, a camera, a pi 3 a+, a joystick and a dpad, and more. (Now that I think about it this is just a 3DS XL without the bottom screen but screw it it’s a MintyPi+)

Really.....

That sounds like an original idea.....

viewtopic.php?f=32&t=4446



.

The xl looks like a game boy
If I were to make the + it would retain the DS look

StaticNebula26 wrote: ↑

Tue Mar 12, 2019 3:55 pm

VeteranGamer wrote: ↑

Mon Mar 11, 2019 6:32 am

StaticNebula26 wrote: ↑

Sun Mar 10, 2019 10:05 pm

Not sure if I should even call this idea a mintpi anymore. So essentially it would be a MintyPi but with a bigger 3Dprinted enclosure so I could fit a bigger screen, a camera, a pi 3 a+, a joystick and a dpad, and more. (Now that I think about it this is just a 3DS XL without the bottom screen but screw it it’s a MintyPi+)

Really.....

That sounds like an original idea.....

viewtopic.php?f=32&t=4446



.

The xl looks like a game boy
If I were to make the + it would retain the DS look

OK....

well, good luck with that.....
please post your progress




.

gamingbro wrote: ↑

Tue Mar 12, 2019 3:25 pm

can you put it in a bigger tin

I saw a special 5oz (147ml) Christmas altoids tin on amazon but I don’t think it’s hinged and it’s out of stock.

There’s also a 10 oz altoids tin for around $300 usd on antique sites, so for obvious reasons I won’t get one those either.

Unless I can find a cheap plain tin that’s bigger than the standard altoids, the best choice would be a 3d printed enclosure.