I decided that I wanted to make a PCB to house LEDS in place of the bulb and so I went looking for some parts to drive the LEDs and invert the AC to DC, I found one with good power ratings but when I actually tested it it burned out 20 o the 24 LEDs. The unit was faulty and was going from 13v DC to 30v DC so I junked it and got another one which has been working so far, this has to be small so it fits at the base of the lamp.
So here are the parts I ordered to fit the lamp:
LED Driver (10W version):
http://www.ebay.com/itm/AC90-250V-to-DC ... tQRmJESjXw
LEDs:
http://www.ebay.com/itm/100PCS-1210-352 ... Swo3pWcm0S
The PCB I made:
![Image](https://s25.postimg.cc/53b50tnzj/Lamp_PCB.jpg)
PCB with LEDs in Lamp Head:
![Image](https://s25.postimg.cc/bia5xhupb/PCB_in_Place_1.jpg)
![Image](https://s25.postimg.cc/ny6vr8o1b/PCB_in_Place_2.jpg)
Lamp Light Off (ignore the mess!!):
![Image](https://s25.postimg.cc/me1jsufn3/Lamp_Off.jpg)
Lamp Light On:
![Image](https://s25.postimg.cc/wpdwli7cf/Lamp_On.jpg)
A cheap upgrade and works great in this dim lit work area.