WII U RASPBERRY PI 3 FINISHED

[Guinan]

The tp4056 can charge any mAh battery but charging time depends of the capacity . If you going to use those batteries in series you must use 1S protection as the output voltage is 4.2V. 4S protection is for 4 cell in series with output voltage 16.8V and you cannot use Tp4056 for charging.

For the mic question on the usb dac there is a dedicated audio jack for mic when you use something like this http://www.ebay.co.uk/itm/USB-External- ... SwWxNYtIO3. The one I have used has only audio out.

Hey thanks! That answered my questions. I've bought that DAC. Thanks for the input.

[nicky1664]

Hi banjokazooie! Amazing Project ! I'm checking everything if I can do this my self. I have two questions actually.
1/ Why one your diagram you don't have any connection between the LCD Driver an the Raspberry Pi? You have the connection with the hdmi port.

2/ Why you have one strange metal stuff on the USB of Teensy 2.0?

Thanks and again great job!

[cvp]

Don't use TP4056 in this configuration. If you want higher charging current use something like this http://www.ebay.co.uk/itm/172591594393? ... EBIDX%3AIT

Remember to put battery protection on unprotected cells and then connect them to charging circuit and rpi

I have overlooked something serious.
But the combination with TP4056 (including protection circuit) AND adafruit Powerboost 1000 (no C!) Would suffice?

[banjokazooie]

Don't use TP4056 in this configuration. If you want higher charging current use something like this http://www.ebay.co.uk/itm/172591594393? ... EBIDX%3AIT

Remember to put battery protection on unprotected cells and then connect them to charging circuit and rpi

I have overlooked something serious.
But the combination with TP4056 (including protection circuit) AND adafruit Powerboost 1000 (no C!) Would suffice?

Would suffice for what?.

[cvp]

Would suffice for what?.

I mean to replace the separate Lipo Charger + Protector Board with this constellation. Will it work to recharge the batteries while playing?

[banjokazooie]

Would suffice for what?.

I mean to replace the separate Lipo Charger + Protector Board with this constellation. Will it work to recharge the batteries while playing?

It will work same as in my setup. Will recharge battery but at only at 1A rate.

[Racerboy]

So is there anything you wish you had done different? How's the battery life on it? Speakers have good quality sound?

[MagicTurtle]

Rad

[banjokazooie]

So is there anything you wish you had done different? How's the battery life on it? Speakers have good quality sound?

I would change the 1S lipo and powerboost combination to 2S lipo and pololu step down converter. This will provide slightly better battery life and not inducing a lot of noise in power lines. Speakers are OK considering the size.

[reke]

hi there, im new here, sorry for my bad english, im from mexico, and i want to build a gamepad for a gift, i have some questions and i would if somebody could helping me, can i use de original gamepad lcd?, the analog joystick with teensy works fine?

thanx

i have a gamepad but i dont use anymore