Re: WII U RASPBERRY PI 3 FINISHED
Posted: Mon Feb 04, 2019 2:45 pm
Leave it plugged in before boot.
Did that and tried it again just now but nothing. I went ahead and bought another Teensy because its the only thing I can thing of that might be the issue. Flashing a script to it shouldnt break it, but the moment I do nothing works on that same pc again unless I move to a brand new pc thats never seen the teensy before. New one comes in Wed so ill keep every one posted.
Just got my new Teensy board, uploaded the sketch and windows still saw the device. Booted up my retro pi and went to controller config and BOOM sees the Teensy! and the button presses! So my Teensy was either bad from start or I messed it up. Either way I should be good from here.blu3rav3n wrote: ↑Mon Feb 04, 2019 8:42 pmDid that and tried it again just now but nothing. I went ahead and bought another Teensy because its the only thing I can thing of that might be the issue. Flashing a script to it shouldnt break it, but the moment I do nothing works on that same pc again unless I move to a brand new pc thats never seen the teensy before. New one comes in Wed so ill keep every one posted.
Im pretty sure he had that custom made and the schematics to have your own made is on here somewhere.jbenedetto84 wrote: ↑Wed Feb 06, 2019 6:08 amHi. Can you tell me where you got the perforated sheet for where the camera was? I'm having a hard time sourcing it.
https://www.ebay.co.uk/itm/10PCS-Cuttab ... ctupt=truejbenedetto84 wrote: ↑Wed Feb 06, 2019 6:08 amHi. Can you tell me where you got the perforated sheet for where the camera was? I'm having a hard time sourcing it.
VeteranGamer wrote: ↑Mon Jan 21, 2019 12:19 pm
just a quick update.....
I received all the parts required (actually received them last week)
I've just been so busy, and I hope to have it installed by this weekend and test it out....
VeteranGamer any updates on the board and the parts for it??
Would like to get a few boards and the required parts once they are made available.
Don’t give up....blu3rav3n wrote: ↑Fri Feb 08, 2019 10:31 pmWhelp I fired this Teensy too some how. it was working ish. Couldn't get left joystick to recognize left or right only up and down and right joystick to see any direction. Now it dosnt work at all. Not in windows not on the pi, nothing..............pretty sure im done with this project forever since it seems this part of it is bull and just donst work. If someone wants to finish this for me I will compensate you and any parts needed or if anyone needs any parts pm me.
Well if you used the code I gave you and wired up the TX pin the shutdown will only work when the pi has shutdown properly using the battery script of using the menu to choose shutdown. Of course if you hold the button in for a bit it will do a forceful shutdown as it is useful for those time the Pi might freeze and there is no way to do a proper shutdown.VeteranGamer wrote: ↑Sat Feb 09, 2019 10:19 am
which will give me a shutdown button (which I've used the TV button for)
so all I've been able to test is the Power Button, and that seems to turn the system On and Off without any issues....
(which as it is, may not be great for the SD card)