sudomod

Hey guys just showing of my bartop arcade...anyone from Australia who was a teen in the 1980s and 90s will know where I got the marquee name from.

Nice job, I do a couple bartops myself.

Very nice setup. Did you cut the cabinet yourself, or was it a flat pack? I ask because I'm considering making a bartop with some salvaged laptop lcds but all the flat packs I've been seeing are for 17,19 or 21/22 inch monitors.

Very nice! What do you have running it?

Going to move this to the project show-off area where more people will see it.

RarinImp wrote: ↑

Fri May 26, 2017 3:38 pm

Very nice setup. Did you cut the cabinet yourself, or was it a flat pack? I ask because I'm considering making a bartop with some salvaged laptop lcds but all the flat packs I've been seeing are for 17,19 or 21/22 inch monitors.

Thank you very much. I did cut them myself, not sure if i can post direct links to what i based it around, but I found most of the things i need on http://www.instructables.com/

wermy wrote: ↑

Fri May 26, 2017 3:45 pm

Very nice! What do you have running it?

Going to move this to the project show-off area where more people will see it.

Thanks for the reply. I used a Raspberi pi 3 with Emulation Station. For a screen I cannibalized an old 15 (or 17?) inch monitor. For controls I bought:

http://www.ebay.co.uk/itm/2-Player-Arca ... SwYIxX4lGl (Surprisingly good quality)

If i want player 2 i have an XBOX 360 wireless controller dongle connected and configured
For audio i bought a cheapo €15 amplifier and €10 speakers

As for tools all i used to cut the wood was a jigsaw and MK1 eyballs nothing elaborate (sandpaper,screwdrivers etc)

Thump52 wrote: ↑

Fri May 26, 2017 9:31 am

Nice job, I do a couple bartops myself.

Please share if able. Thanks.

Here's one I put together a couple years ago using an ion iCade as the housing: https://instagram.com/p/BUUqVhjF8dL/
Still works great, upgraded it with a pi 3 recently.

wermy wrote: ↑

Sat May 27, 2017 8:34 am

Here's one I put together a couple years ago using an ion iCade as the housing: https://instagram.com/p/BUUqVhjF8dL/
Still works great, upgraded it with a pi 3 recently.

So cool and original, what screen did you use ?

Thanks! It uses an old, used 12.1" Dell laptop LCD panel, along with a controller board for it (I think it was about $50 together, so not too bad). Also uses one of these for the controls: http://www.ebay.com/itm/251241991403?_t ... EBIDX%3AIT